REM Archives - Seite 2 von 3 - REM Surface Engineering

3Degrees Discussions #81 – Justin Michaud – REM Surface Engineering

Posted by Danny Estrada on Montag, März 14th, 2022 in

...

NASA SPINOFF – Some Engineering Is Only Skin Deep

Posted by Danny Estrada on Montag, Januar 31st, 2022 in

So he contacted REM Surface Engineering of Southington, Connecticut. Founded by CEO Justin Michaud’s grandfather as a decorative plating supply […]...

Metal Finishing for 3D Printed Parts Webinar – Part 7 – OPEN IMPELLER

Posted by Danny Estrada on Montag, Juli 6th, 2020 in

...

Metal Finishing for 3D Parts Webinar – Part 2

Posted by Danny Estrada on Montag, Juli 6th, 2020 in

...

Metal Finishing for 3D Printed Parts Webinar – Part 1

Posted by Danny Estrada on Montag, Juli 6th, 2020 in

...

Gear designers and manufacturers will need to review and update their tooth flank roughness specifications based on the new ISO 21920 GPS family of standards.

Changes Ahead in the Roughness Standards

Posted by Mark Michaud on Freitag, Mai 15th, 2020 in

I have written numerous articles on tooth flank surface roughness measurement. This is such a page-turner of a subject!...

Materials Matter : Roughness Measurement Tips: Calibration, the Razor Blade Test

Posted by Mark Michaud on Dienstag, Februar 25th, 2020 in

If a problem is found with a contact stylus profilometer during routine check with a Rubert-Song specimen, do a little troubleshooting before sending it off for calibration and recertification....

A Comparison of Surface Roughness Measurement Methods for Gear Tooth Working Surfaces

Posted by Mark Michaud on Freitag, Oktober 25th, 2019 in

Surface roughness is a critical parameter for gears operating under a variety of conditions. It directly influences friction and contact temperature, and therefore has an impact on various failure modes such as macropitting, micropitting and scuffing...

Vibratory Media Compositions vs. Attrition and Density

Posted by Bill Nebiolo on Dienstag, Oktober 1st, 2019 in

The third in our multi-part series on vibratory processing of gears is focused on understanding how media of different compositions have varying attrition rates and densities, and why these are important in vibratory finishing of gears. ...

AN ANALYSIS OF A LOSS OF LUBRICATION TEST OF ISOTROPIC SUPERFINISHED GEARS WITHOUT BLACK OXIDE COATING

Materials Matter : Surface Finishing Rotorcraft Gearing

Posted by Danny Estrada on Mittwoch, Oktober 3rd, 2018 in

Rotorcraft gearboxes are designed with the utmost precision to withstand the tremendous demand and loads required to convert thousands of horsepower and RPM into hundreds of RPM and lift torque....

Gear Expo Live! Ask the Expert with Mark Michaud

Posted by Mark Michaud on Freitag, Februar 23rd, 2018 in

...

Future Advanced Rotorcraft Drive System (FARDS) Full Scale Gearbox Demonstration

Posted by Danny Estrada on Dienstag, Juni 6th, 2017 in

The Future Advanced Rotorcraft Drive System (FARDS) program focused on improving the performance and affordability of current aircraft drive systems....